To make the necklace, you will need:
- A chain of 50cm
- A 5mm spring clasp
- A cabochon 12mm
- A pendant with set for cabochon 12mm
- Crystal araldite glue
- Pliers
- Gloves

1. Stick the cabochon on the support, and wait about 20min, so that the glue dries.
2. Thread your chain inside the ring of the pendant.
3. Add your clasp on the chain (the ring of the clasp is open).

Before wearing your collar, we advise you to wait 2 hours, for the final glue.

Use of Jewelry Glue
- Remove the plug located between the pistons, which will serve you to close the glue.
- Break the end of the measuring cup.
- Press on the piston. We advise you to handle with a pair of gloves.
- Make sure to close the end of the measuring cup.
- Thoroughly mix the 2 components for at least 30 seconds, until a homogeneous paste is obtained.
- Apply this mixture on the stone to stick (a little bit is enough, not to avoid that it overflows)

You can also put several pendants. It will be sufficient to fix the pendants with the help of a 4mm open ring
. Here is an example :